What it is:

A new Controller board Designed by JNP In collaboration with the Voron team and Manufactured by LDO. This Feature packed monster is everything you need to make your voron print fast and reliable, while offering everything you could need for expansion.

Special Deal

• Get 5$ off and Free shipping when you add an LDO Nitehawk PCB (rev D bundle kit)

Specifications:

• Supports Klipper firmware
• STM32F446 MCU
• 1x Vin 24V main supply (polarity and overvoltage protected)
• 1x Vin 24-48V TMC5160 supply (polarity and overvoltage protected)
• 5x TMC2209 onboard drivers (24V)
• 2x TMC5160 onboard drivers (24-48V), onboard 12V source for gate drive
• 4x Thermistor inputs
• 4x Fan outputs (with tacho signal support, 5/24V via jumpers)
• 1x Probe input (5/24V via jumper)
• 1x Filament sensor input (5V tolerant)
• 1x Neopixel output
• 3x Endstop inputs (5V tolerant)
• 1x Hotend heater output (max. 180 W, 7.5 A)
• 1x Heatbed heater output (max. 240 W, 10 A)
• 1x dimmable LED-strip output (350mA constant current source)
• 1x EXP1 port
• 1x EXP2 port
• 1x Extension port (4x ADC, 1xUART, 1xSPI or 1xCAN, 10GPIO, 3.3V@0.5A, 5V0.5A, 24V@0.5A)
• 1x STM32 programmer interface (backup)
• 1x USB-C interface
• 1x CAN Bus interface (MicroFit 3.0 connector)
• 1x RPi Powersupply (5-pin JST-XH connector with UART support)
• Mounting holes for RPi Zero 2W and RPi3/4
• Improved stepper driver cooling
• Dimensions: 170x100mm, Mounting holes: 160x90mm

 Documentation coming soon