We are proud to release our take on Edge to Edge Heaters 
Featuring:

• True edge-to-edge design on the outside and inside- our Arlon bed heaters go to the edge of your build plate with both the heating element and the covering element making for a true edge-to-edge heater. 
• Ratrig Specific sizes-  Designed by our team and tested in house to make sure these fit like a glove. 
• Made with safety in mind- Our heaters are past various certifications including CE and come with an integrated 150c Thermostat that will disconnect power temporarily in the event of a thermal runaway.  We still recommend using an external sensor based on the build specs of the printer used. in fact we have taken into account possible install locations used by various Bed manufacturers for a smooth installation experience. 
• Set klipper to Generic 3950 thermistor type

**NOTE: due to the reflective nature of Mic6 direct readings did not show correct temperatures, all other areas were within normal tolerances (PEI, Arlon, Heater, Wires) ** 

Ratrig Vminion now available, Vcore will follow